Purdy PSW Junior Land Leveler

Click on the Photos for a Full Picture

Purdy PSW Junior Fact Sheet

1. For smaller horsepower tractors
2. 12' cut x 35' long, mounted on a 10'-wide frame
3. Rigid blade is standard; trip blade is optional.
4. The three blades can be swung under the frame to 12' width, for easy movement. The number one pick-up blade actually reaches out 3' past the frame, so as to allow plenty of clearance between the discharge ridge and the dual tires.
5. Each blade has its own reinforcing frame, with 10" channel moldboards and 1/2" x 6" double-bevel reversible blades; this allows for dirtcarrying capabilities. Other machines have only a blade mounted on a beam--- hit a ridge, dirt rolls over--- that is not leveling.
6. Each blade has its own leveling adjustments, plus adjustments with the lift rods.
7. Each blade is set at a steep angle, to allow you to work heavy and trashy ground, plus move more dirt.
8. The curvature of the blade and unique tilt of the moldboard rolls the dirt for easier pulling.
9. Four dual-wheel assemblies --- conventional or rocking-axle.
10. Outside duals are 10' wide, outside to outside, for stability and to eliminate bounce; inside duals are 3'5" wide, inside-to-inside, for narrow bridges.
11. 9.5 x 15 rib implement tires, for more floatation, less bounce, less field compaction, and more stability.
12. Eight 5,200 1 lb. -payload -capacity hubs and spindles --- 41,600 total capacity.
13. Three heavy bottom runners, plus 6'-tall arches and knee bracing in the center, to eliminate bounce and bending in the turns.
14. The depth control stop allows for precision cuts, eliminates irregular cuts.
15. The positive-steering controls allow for straight tracking on the road and in the field, without the machine's drifting from one side to another.
16. The rear wheels track within 12" of the front in a turn, and the leveler is easy to back up.
17. Rear hydraulic steering, for maneuverability and ease of handling.
18. The leveler has a short turning-radius.
19. Once mechanically set, the only adjustment is the depth.
20. The leveler is designed for easy maintenance and, when needed, easy repair: (a) bolt-in spindles; remove bolts; call the plant; eliminate a welder; optional rocking wheel assembly has weld-in spindles. (b) wheel assembly housings are bolt-on (c) heavy brass wear bushings, instead of having a shaft running a tube; slack in the housing --- replace bushings (d) entire blade assembly can be dropped, not cut off, from the machine.
21. Recommended h.p. --- 80 and up. This unit was tested with an International 760, 80 h.p., single tires, no front-end weights, and then durability tested with a 170 h.p. Allis Chalmers tractor.

Custom Built Products

We regularly design and create equiptment according to the specifications of our customers. It may be a variation of one of our stock items, or something not routinely manufactured.

We have good used and re-conditioned equipment, taken as trade-in or bought for re-sale.

Our objective is to meet our customers' demand for the highest quality land-forming and agricultural implements.

Get our recommendations and a quotation right now!
We also have good used equipment available from time to time